Filter
Top Products
11
4. Place the hooked ends of the other power supply cable wires under the outer terminal
block screws (hooks facing right). Squeeze hooked ends together. Tighten screws.
5. Tighten strain relief screws.
6. Insert tab of term
inal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
7. Y
ou have completed your electrical connections. Now go to “Venting Requirements.”
3-wire connection: Power Supply Cord
Use where local codes permit connecting cabinet-ground conductor to neutral wire:
A
B
D
C
E
F
G
A.3-wire receptacle (NEMA type 10-30R)
B.3-wire plug
C.Neutral prong
D.Spade terminals with up turned ends
E.¾" (19 mm) UL listed strain relief
F. Ring terminals
G.Neutral (white or center wire)
1. Loosen or remove center silver-colored terminal block screw.
2. Connect neutral wire (white or center wire) of power supply cord to the center, silver-
colored terminal screw of the terminal block. Tighten screw.
A
B
C
D
E
A.Neutral ground wire
B.External ground conductor screw
C.Center silver-colored terminal block screw
D.Neutral wire (white or center wire)
E.¾" (19 mm) UL listed strain relief
3. Connect the other wires to outer terminal block screws. Tighten screws.
4. T
ighten strain relief screws.
5. Insert
tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
6. Y
ou have completed your electrical connections. Now go to “Venting Requirements.”
3-wire connection: Direct Wire
Use where local codes permit connecting cabinet-ground conductor to neutral wire.
Direct wire cable must have 5 ft (1.52 m) of extr
a length so dryer can be moved if needed.
Strip 3
1
/2" (89 mm) of outer covering from end of cable. Strip insulation back 1" (25 mm). If
using 3-wire cable with ground wire, cut bare wire even with outer covering. Bend ends of
wires into a hook shape.
1"
(25 mm)
3½"
(89 mm)