Filter
Top Products
12
When connecting to the terminal block, place the hooked end of the wire under the screw of
the terminal block (hook facing right), squeeze hooked end together and tighten screw, as
shown.
1. Loosen or remove center silver-colored terminal block screw.
2. Place the hooked end of the neutral wire (white or center wire) of power supply cable
under the center screw of terminal block (hook facing right). Squeeze hooked end
together. Tighten screw.
B
C
D
E
A
A.Neutral ground wire
B.External ground conductor screw
C.Center silver-colored te
rminal block screw
D.Neutral wire (white or center wi
re)
E.¾" (19 mm) UL listed strain relief
3. Place the hooked ends of the other power supply cable wires under the outer terminal
block screws (hooks facing right). Squeeze hooked ends together. Tighten screws.
4. Tighten strain relief screw.
5. Inser
t tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
6. Y
ou have completed your electrical connections. Now go to “Venting Requirements.”
Optional 3-wire connection
Use for direct wire or power supply cord where local codes do not permit connecting
cabinet-ground conductor to neutral wire.
1. Remove center silver-colored terminal block screw.
2. Remove neutral ground wire from external ground conductor screw. Connect neutral
ground wire and the neutral wire (white or center wire) of power supply cord/cable under
center, silver-colored terminal block screw. Tighten screw.
A
B
C
D
E
F
A.External ground conductor screw
B.Neutral ground wire
C.Center silver-colored terminal block screw
D.Neutral wire (white or center wire)
E.¾" (19 mm) UL listed strain relief
F. Grounding path determined b
y a qualified electrician
3. Connect the other wires to outer terminal block screws. Tighten screws.