Filter
Top Products
21
2. Remove the 4 screws that attach to the inner door hinge and move the hinge to the other
side. Reinstall the 4 screws.
3. Reinstall plug strips on opposite side of the inner door.
4. Check for fingerprints on the glass. Clean glass if necessary.
5. Place the inner door assembly inside the outer door assembly. To fit correctly, the inner
door assembly edge fits completely inside the outer door assembly edge.
6. Reassemble the inner and outer door assemblies with the 6 screws.
Reverse the strike
1. Use a small flat-blade screwdriver to remove plug strip from the dryer door opening. Slide
the head of the screwdriver under the plugs, being certain not to scratch the dryer surface.
Lift up.
2. Remove the strike
3. Insert strike on the opposite side.
Reinstall the door
1. Reattach door to dryer front panel with the 4 screws.
2. Check for fingerprints on the glass. Clean glass if necessary.
3. Close door and check that it latches securely.
A.Door hinge
A
A.Plug strip (cannot be seen from this angle)
B.Door strike
A.Dryer front panel
B. Door assembly
B
A
A
B