Filter
Top Products
B. ADJUSTMENTS
7 DAYS AFTER INSTALLATION and EVERY 6 MONTHS THEREAFTER
Inspect bolts, nuts, screws (bearing set screws), non-permanent gas connections (unions, shut-off valves,
orifices, etc.), electrical terminations, and grounding connections.
Motor and drive belts should be examined. A cracked or seriously frayed belt(s) should be replaced.
Tighten loose belt(s) when necessary and check the alignment.
Complete operational check of controls and valves.
Complete operational check of
ALL safety devices (door switches, lint compartment switches, sail switches,
burner and hi-limit thermostats).
C. LUBRICATION
The motor bearings, idler bearings, and tumbler bearings are permanently lubricated. NO LUBRICATION
IS NECESSARY.