Filter
Top Products
24
3) 3-Phase (3ø) Wiring Connections or Hookup (for Reversing Models Only)
The electrical connections on ALL 3-phase (3ø) gas dryers are made into the rear service box
located at the upper left area of the dryer.
IMPORTANT: A separate circuit servicing each dryer must be provided.
If local codes permit, power to a gas dryer can be made by the use of flexible U.L. listed power cord/
pigtail (wire size must conform to rating of dryer), or the dryer can be hard wired directly to the
service breaker panel. In ALL cases, a strain relief must be installed where the wiring enters the
dryer.
The only electrical input connections to the dryer
are the 3-phase (3ø) power leads (L1, L2, L3,
and sometimes neutral) and ground. Single-phase
(1ø) power for the control circuit is done internally
to the dryer. No single-phase (1ø) input
connection is required on a 3-phase (3ø) dryer.
For gas dryers manufactured for operation at 3-phase
(3ø), the electrical connections are made at the power
distribution block located in the service box at the
rear, upper left corner of the dryer. The ground
connection is made to the copper lug also provided in
this box. To gain access to the service box contactor,
the service box cover must be removed.