Filter
Top Products
21
3. Grounding
A ground (earth) connection must be provided and installed in accordance with state and local codes. In
the absence of these codes, grounding must conform to applicable requirements of the National Electrical
Code ANSI/NFPA NO. 70-LATEST EDITION, or in Canada, the installation must conform to applicable
Canadian Standards: Canadian Electrical Codes Parts 1 & 2 CSA C22.1-1990 or LATEST EDITION (for
Electrical Connections). The ground connection may be to a proven earth ground at the location service
panel.
For added personal safety, when possible, it is suggested that a separate ground wire (no. 18 minimum)
be connected from the ground connection of the dryer to a grounded cold water pipe. DO NOT ground
to a gas pipe or hot water pipe. The grounded cold water pipe must have metal to metal connection
ALL the way to the electrical ground. If there are any nonmetallic interruptions, such as, a meter, pump,
plastic, rubber, or other insulating connectors, they must be jumped out with no. 4 copper wire and
securely clamped to bare metal at both ends.
IMPORTANT: For personal safety and proper operation, the dryer must be grounded.
Provisions are made for ground connection in each dryer at the electrical service connection area.
4. Electrical Connections
NOTE: A wire diagram is located in the front electrical control box for connection data.
a. Gas Models ONLY
NOTE: A CIRCUIT SERVICING EACH DRYER MUST BE PROVIDED.
1) Single-Phase (1ø) Wiring Connections/Hookup
The electrical connections on ALL single-phase (1ø) gas dryers are made into the rear service box
located at the upper left area of the dryer.