Filter
Top Products
23
Trouble Shooting
Before calling on outside help, first try to put the trouble right with the help of the indications
below.
Trouble Cause What to do
Garments are not
being dried as
expected
The fuses controlling the drying
cabinet have tripped.
The temperature and/or time se-
lector knobs have not been cor-
rectly set.
The drying cabinet has been used
in a room where the temperature
is lower than 0° C
Garments has been badly spun or
is still very wet.
Has the items been hung in the
right way?
Has the temperature selector
knob been set too low?
Are the ventilation pipe/hose too
long?
Check
Control the settings
To work normally, the drying
cabinet must obligatorily be
installed in a room where the
temperature is above 0°C
Check what is hanging in the
drying cabinet.
See the section "Loading".
Control the settings.
They should not be more than
1 metre long.
The drying ca-
binet is not gi-
ving out any heat
even though the
temperature se-
lector knob is ac-
tivated.
Is it plugged in?
Is the fuse in working order?
Is the right fuse being used?
Is the door of the drying cabinet
shut?
Has the time selector knob been
set?
The temperature limiter has been
tripped.
The temperature limiter is faulty
Check.
Check.
Change to a more resistant
fuse.
Check.
Check.
Turn the time switch back to
’0’ and wait 30 minutes. Then
try again by activating the
temperature selector knob
and, after that, start the fan
by turning on the time swith.
Contact Customer Service.