Filter
Top Products
Then the TIME MONITOR will convert to the temperatures are selected. A warm finn rinse cannot be
approximate total minutes remaining in the cycle, provided on a permanent press cycle or when using a hot
This feature lets you know when to return to the or cold wash temperature on any cycle.
washer to remove >'our load. Start the Washer
Select Options After a wash cycle program has been selected, the wash-
Options are selected by pressing the pad once or er ,a411fill to the selected water level with the selected
canceled by pressing the pad again, wash water temperature. After lqlling, it will agitate for
Slow Spin the selected nmnber of minutes.
Pressing this pad provides a slow spin speed on any The washer will pause briefly throughout each
cycle selected, eyele. These pauses are normal.
Off This washer is designed so that it will not agitate or spin
Pressing this pad cancels all selections and stops the when the lid is open. It will, however, fill with the lid
washer, open so water is available for pretreating stains or dilut-
ing fabric softener.
Presoak
Should the lid be opened during a eyele, the washer will
This option provides a convenient and eeonomical
stop; when the lid is dosed the washer will resmne its
method of treating heavily soiled and stained loads, cycle at the point it was interrupted.
It will soak with brief periods of agitation for a
selected time and automatically advance into a NOTE: Ifthewasher stops during the spin it maybe
wash cycle without draining, due to an unevenly distributed load. If this_happens,
To use this option: push in the controlknob, open the lid, redistribute the
1. Select a wash cycle, load, close the lid and pull out the control knob,
2. Choose wash temperature, water level and wash Program Monitor Features
time.
Unbalanced Signal
3. Press PRESOAK pad. (Wash water temperature
and presoak water temperature will be the If the washer stops due to an unevenly distributed
same,) clothes load, "UNBALANCED" will light in the
Monitor. One minute later an audible signal will sound.
4. If needed, decrease presoak time from 30 rain- This signal will continue to sonnd every minute. To con-
utes or increase time up to 60 minutes by press- tinue the cycle, redistribute the load and close the lid.
ing one of the time adjust pads. Generally, soak The washer will automatically resume the cycle at the
periods up to 30 minutes are sufficient for most point it was interrupted.
loads.
Sequence Indicators
5. Use up to 50% more than the usual amomat of
Words light in the Monitor as the washer advances
detergent or use a presoak product such as Biz°
through each portion of the %vole -- "SOAK, WASH,
in addition to the regular amount of detergent. RINSE, X-RINSE and SPIN."
*Brandna_r_aretheo'ademarksof&e_pective nuznufacturer_.
Extra Rinse Soil Level indicators
The soil level indicators will light in the Monitor to help
An additional deep rinse is automatically added to match the wash time to the soil level of the load. For
the selected cycle by using the EXTRA RINSE example, if the load is lightly soiled, agitation time can
option. To select, press the EXTRA RINSE pad. be decreased and fewer indieator lights will light indi-
The water temperature will be the same as the ini- eating appropriate agitation time for the load.
tial rinse.
Warm Rinse
Pressing this pad will provide a warm final rinse when
energy saver hot, warm or energy saver warm water
PAGE 7