Filter
Top Products
OPERATING INSTRUCTIONS
Using the Washer at a Glance 4. Change the wash time by pressing the TIME
ADJUST pad - • to decrease time or • to increase
Operating the washer can be as simple as touching one time.
cycle pad. The pre-programmed wash cycles automati-
cally provide warm water washes, cold water rinses and 5. Select other desired options by pressing the appro-
extra large water levels, priate pads.
However, cycles can also be changed to fit load varia- Please read the following detailed instructions on how
tions. They can even be programmed for customized to best use this washer.
care of special wash loads. Select Wash Cycle Program
After adding proper laundry additives and placing the
load in the wash tub: Pre-Programmed Cycles
For REGULAR FABRIC loads, press the REGU-
1. Press a wash cycle program pad. (When a pad is LAR FABRICS pad. After a slight pause, the washer
properly pressed, an audible tone will be heard and a will fill and automatically select an Extra Large Water
red indicator will light.) A warm water wash and cold Level, Warm Wash/Cold Rinse and 10 minutes of agi-
rinse in a full tub of water is automatically provided, tation. "Wash 10 Minutes" will appear in the Monitor.
If these are appropriate for the load, there is no need
(To change these options see the following section.)
to make any other selections. Use this cycle for everything washable except
If a previous load has not been removed, the washer permanent press, delieates and woolens.
will not acknowledge the cycle selection. The word
For PERMANENT PRESS loads, press the PERM.
"lid" will appear in the Monitor. To continue, the lid PRESS pad. After a slight pause, the washer will f_ll
must be raised and lowered and the wash cycle re- and automatically select an Extra Large Water Level,
selected. Warm Wash/Cold Rinse and 8 minutes of agitation.
Cycle selection can be changed while the washer is "Wash 8 Minutes" will appear in the Monitor. (To
filling by pressing another cycle pad. After the fill is change these options see the following section.) Use
complete the cycIe cannot be changed, this cycle for permanent press items and synthet-
If the pre-progranamed options are not appropriate for ies (nylon, polyester, acrylic, ere.). This cycle auto-
matically provides a cool down rinse to minimize wrin-
the load: kling when hot or energy-saver hot wash temperatures
2. Change the wash temperature by pressing the are used.
WASH TEMP ADJUST pad. For KNIT and DELICATE loads, press the KNITS/
3. Change the load size by pressing the WATER DELICATES pad. After aslightpause, the washerwilI
LEVEL ADJUST pad. fill and automatically select an Extra Large Water
NOTE: If you experience problems selecting the correct water temperature, or cycle, or starting the
washer, reler to page 9 for additional information before calling for service.
PAGE 4