Filter
Top Products
BEFORE YOU CALL FOR SERVICE
Check these points if your washer...
WON'T FILL • Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Select wash cycle by touching appropriate program pad. If"lid" appears in the mon-
itor, raise mad lower lid and re-select wash cycle.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and check hose filter screens. Clean screens, if plugged.
WON'T AGITATE • Check fuse or reset circuit breaker.
• Close lid, For your safety, washer will not agitate or spin unless the lid is dosed.
The washer is equipped ruth a hd _tch failure detector. If the hd smtch appea s
in monitor, raise and lower hd. If "lid remains displayed. Call for service.
Hose filter screens plugged. Disconnect hose and clean screens.
WON'T SPIN OR DRAIN • "Unbalanced" appears in monitor and signal sounds. Redistribute the load evenly and
close the hd. Check for leveling. Be sure water level is acceptable for load size.
• Check fuse or reset circuit breaker.
Select wash cycle by touching appropriate program pad.
Straighten hoses. Eliminate Milked hoses. If there is a drain restriction, call for service.
• Close lid. For your safety, washer will not agitate or spin unless the lid is dosed.
• Suds lock- caused by too much suds. Rewash without detergent. Use correct amount
of a low-sudsing detergent.
• The washer is equipped with a lid switch failure detector. If the "lid" appears in
monitor, raise and lower the lid. If "lid" remains displayed, call for service.
• "Unbalanced" a ears in monitor and signal sounds Redistribute the load evenly and
STOPS PP '
close the lid. Check for leveling. Be sure water level is acceptable for load size.
Plug cord into live electrical outlet.
Check fuse or reset circuit breaker.
Select wash cycle by touching appropriate program pad.
Straighten hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.
• Close lid. For your safety, washer will not agitate or spin unless lid is dosed.
• This may be a pause or soak period in the cycle. Wait several minutes and it may start.
• Suds lock - caused by too much suds. Rewash without detergent. Use correct amount
of low-sudsing detergent.
• The washer is equipped with a lid switch failure detector. If "lid" appears in moni-
tor, raise and lower lid. If "lid" remains displayed, call for service.
LEAKS WATER * Make sure hose connections are tight_
• Make sure end of drain hose is correctly inserted and secured to drain facility'.
• Extended soaking - soak for 30 minutes or less.
IS NOISY • Make sure washer is level and firm to the floor.
• Weak floors can cause vibration and walking.
FILLS WITH TIlE WRONG • Turn both faucets on fully.
TEMPERATURE WATER • Make sure temperature selection is correct.
• Make sure hoses are connected to correct faucets and inlet connections. Be sure
water supply is regulated correctly. Flush water line before f'rJlingwasher.
• Be sure water supply is regulated correcdy.
• Flush water line before idling washer.
• Check the Water heater. It should be set to deliver a minimum 120°F (49°C) hot
water at the tap. Also check water heater capacity and recovery rate.
• Hose filter screens plugged. Disconnect hose and clean screens.
NOTE: For further information contact Maytag Customer Assistance: U.S. 1-800-688-9900
Canada 1-800-688-2002
PAGE 9