Filter
Top Products
32
roubleshooting guide
T
Error Messages
Symptom Possible Cause Solution
• Water supply is not adequate in
area.
• Water supply taps are not
completely open.
• Water inlet hose(s) are kinked.
• The filter of the inlet hose(s) are
clogged.
• If water leakage occurred in the
inlet hose, indicator “
” will be changed red color.
• Drain hose is kinked or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance detection
and correction system. If individual heavy
articles are loaded (ex. bath mat, bath robe,
etc.) this system may stop spinning or even
interrupt the spin cycle altogether.
• If the laundry is still too wet at the end of the
cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.
• Ensure door is not open.
• Water overfills due to the faulty water
valve.
• Water level sensor has malfunctioned.
• Over load in motor.
• The washer experienced a power failure.
• Water leaks.
Check another tap in the house.
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning.
Close the door completely.
If “ ”is not released, call for service.
(CIC call center for the Germany
customer : 01805 473784)
Unplug the power plug and call for service.
(CIC call center for the Germany
customer : 01805 473784)
.
Close the water tap.
Unplug the power plug.
Call for service.
(CIC call center for the Germany
customer : 01805 473784)
Allow the washer to stand for
30minutes to allow the motor to cool;
then restart the cycle.
Restart the cycle.
Call for service.
(CIC call center for the Germany
customer : 01805 473784)
<Fig 1>