Filter
Top Products
19
ENGLISH
INSTALLATION INSTRUCTIONS
Connecting inlet hose
The dryer must be connected to the cold water tap using the new water supply hose. Do not use old hoses
NOTE
• Water supply pressure must be between 14.5 PSI and 116 PSI (100~800 kPa).
• Do not strip or cross-thread when connecting inlet hose to the valve.
• If the water supply pressure is more than 1000 kPa, a decompression device should be installed.
• Periodically check the condition of the hose and replace the hose if necessary.
• Replace inlet hoses after 5 years of use to reduce the risk of hose failure.
• Record hose installation or replacement dates on the hoses for future reference.
3. Connect hose to dryer.
• Connect the water supply hose to the dryer inlet valve tightly by
hand and then tighten another 2/3 turn with plier.
Make sure that there are no kinks in the hoses and that they are
not crushed.
4. Turn on cold water faucet.
5. Check for leaks at the Y-connector (if used) and all hoses.
NOTE
• If any leaks are found, shut o the water faucet, remove the
hose and check the condition of the hose washer.
1. Check rubber seal in the inlet hose. Two rubber seals are
supplied with each inlet hose. They are used for preventing
water leaks. Make sure the connection to the cold water tap is
tight.
Hose
connector
Y connector
2. Check the installation type.
Long
hose
WITH WASHER
Short
hose
a. Shut off the cold water tap and remove the washer hose.
b. Connect the short hose to the Y-conncetor using one of the
hose washers.
c. Connect the other end of the short hose to the cold water
faucet.
d. Connect the long dryer hose to one side of theY-connector and
connect the washer hose to the other side.
a.
Connect the straight end of the long hose to the cold water faucet.
NOTE
• Before connecting the water line to the dryer, ush several
gallons of water into a drain or bucket. This will help prevent
foreign particles such as sand and scale from cloggong the
dryer inlet valve.
• Do not overtighten. Damage to the coupling can result.
Rubber seal
WITHOUT WASHER