LG Electronics D2532W Clothes Dryer User Manual


 
16
Safety Instructions
Installation Instructions
Operating Instruction
Troubleshooting Tips
Customer Service
ELECTRICAL REQUIREMENTS - GAS DRYER
NOTE : A qualified electrician should check the
polarity of the wall receptacles. If a voltage reading is
measured other than that illustrated, the qualified
electrician should correct the problem.
DO NOT OPERATE OTHER APPLIANCES ON
THE SAME CIRCUIT WHEN THIS APPLIANCE
IS OPERATING. DO NOT OVERLOAD
CIRCUITS!
DO NOT operate both a washer and gas dryer on the
same circuit. Use separately fused 15 Amp circuits.
Gas Dryers
(120 Volt, 60 Hertz, with 3-Prong Grounding Plug)
NOTE : The wiring diagram is located inside the
control panel, inside the control cabinet.
The dryer is designed to be operated on a separate
branch, polarized, three-wire, effectively grounded,
120 Volt, 60 Hertz, AC (alternating current) circuit
protected by a 15 Ampere fuse, equivalent fusetron
or circuit breaker.
The three-prong grounding plug on the power cord
should be plugged directly into a polarized three-slot
effectively grounded receptacle rated 120 Volts AC
(alternating current) 15 Amps. Refer to Figure 22 to
determine correct polarity of the wall receptacle.
WARNING
To reduce the risk of fire, electric shock or
personal injury, all wiring and grounding
MUST confirm with the latest edition of the
National Electrical Code ANSI/NFPA 70 or
the Canadian Electrical Code, CSA C22.1,
and such local regulations as might apply.
It is the customer’s responsibility to have
the wiring and fuses checked by a qualified
electrician to make sure the laundry room
has adequate electrical power to operate
the dryer.
WARNING
To reduce the risk of an electric shock or
fire, DO NOT use an extension cord or an
adapter to connect the dryer to the
electrical power source.
DO NOT OVERLOAD
CIRCUITS
DO NOT USE AN
ADAPTER
DO NOT USE AN
EXTENSION CORD
WARNING
This dryer is equipped with a three-
prong (grounding) plug for your
protection against shock hazard and
should be plugged directly into a
properly grounded three-prong
receptacle. Do not cut or remove the
grounding prong from this plug.