Filter
Top Products
5
USING YOUR
WASHER
Understanding Washer
Cycles
When the Cycle Control knob is set to a number and pulled
out, the washer fills (to the selected load size) before
agitation and timing start. The washer begins agitating
immediately after filling; agitation occurs with the washer
lid up or down.
During agitation, the agitator creates a continuous rollover
action that provides a thorough cleaning of the wash load.
After agitation starts, the Cycle Control knob turns
clockwise until it points to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout each cycle.
These pauses are normal for washer operation.
Loading
Loading suggestions
For these suggested full-sized loads, set the LOAD SIZE
selector to the highest load size setting.
Normal Washer Sounds
Your new washer may make sounds your old one didn’t.
Because the sounds might be unfamiliar, you may be
concerned about them. These sounds are normal.
During washing
When you select a small load size setting, your washer has
a lower water level. This can cause a clicking sound from
the upper part of the agitator.
During drain
If water is drained quickly from your washer (depending on
your installation), you may hear air being pulled through
the pump during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you
may hear gears engaging.
WASH RINSE
1. Fill 1. Fill
2. Wash
selected
time
2. Rinse
3. Drain
†
No agitation
3. Drain
No agitation
4. Spin 4. Spin-Spray
rinse
5. Spin
†
The Permanent Press
cycle partially drains,
fills, agitates briefly, and
drains.
6. Off
SUPER CAPACITY PLUS WASHERS
Heavy Work Clothes
3 pair pants
3 shirts
4 pair jeans
1 coverall
1 overall
Delicates
3 camisoles
1 quilted robe
4 slips
4 panties
2 bras
2 nighties
1 baby’s dress
Towels
10 bath towels
10 hand towels
14 wash cloths
1 bath mat
Mixed Load
3 double sheets
4 pillowcases
8 T-shirts
6 pair shorts
2 shirts
2 blouses
8 handkerchiefs