Filter
Top Products
PowerSupplyCord DirectWire
FireHazard
Usea newULapproved30amppower
supplycord.
Usea ULapprovedstrain relief.
Disconnectpowerbeforemakingelectrical
connections=
Connectneutralwire(whiteorcenterwire)to
centerterminal(silver).
Groundwire(greenor barewire)mustbe
connectedto greengroundconnector.
Connectremaining2supplywiresto remaining
2terminals(gold).
Securelytightenallelectricalconnections.
Failureto do socan resultin death,fire,or
electricalshock.
FireHazard
Use10gaugesolidcopperwire.
Usea ULapprovedstrain relief.
Disconnectpowerbeforemakingelectrical
connections=
Connectneutralwire(whiteorcenterwire)to
centerterminal(silver).
Groundwire(greenor barewire)mustbe
connectedto greengroundconnector.
Connectremaining2supplywiresto remaining
2terminals(gold).
Securelytightenallelectricalconnections.
Failureto do socan resultin death,fire,or
electricalshock.
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
2
4
3.
Assemble a 3/4in. (1.9 cm) UL approved strain relief (UL
marking on strain relief) into the hole below the terminal block
opening. Tighten strain relief screws just enough to hold the
two clamp sections together. Put power supply cord through
the strain relief. The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position.
4. Now complete installation following instructions for your type
of electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
1. Terminal block cover and hold down screw
2. External ground connector
3. Neutral grounding wire (green/yellow)
4. Center, silver-colored terminal-block screw
8