Filter
Top Products
INSTALLATION
INSTRUCTIONS
s Pe 5ss s
Are you placing the dryer on a pedestal? You can purchase a
pedestal separately for this dryer, This pedestal will add about
14 in. (35.56 era) to the height of your unit for a total height of
approximately 52 in. (132,08 em).
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
• Flat-blade screwdriver • Safety glasses
• Adjustable wrench that • Duct tape
opens to 1 in. (2.54 cm)
or hex-head socket • Caulking gun and
wrench (for adjusting compound (for installing
dryer feet) new exhaust vent)
• Level • Gloves
• Wire stripper (direct wire • Tin snips (new vent
installations) installations)
• #2 Phillips screwdriver • V4in. nut driver or socket
wrench
Parts supplied
Remove parts package from dryer drum. Check that all parts are
included.
4 Levelinglegs
NOTE: Do not use leveling legs if installing the dryer on a
pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
• For close-clearance installations between 31.5 in. (80.01 cm)
and 37 in. (93.98 cm), see "Plan Vent System" section for
venting requirements.
I< 87,, >1
(63.98cm)
Mobile home installations require metal exhaust system hardware
available for purchase from your local Sears store or Sears
Service Center. For further information, please call
1-800-4-MY-HOME _ (1-800-469-4663).
Optional pedestal
The pedestal is available in three colors
White - Part Number 42842
Biscuit - Part Number 42844
Graphite - Part Number 42846
To order, call your local Sears store. For further information,
please call 1-800-4-MY-HOME _ (1-800-469-4663).
Lee@:on
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the
floor for a garage installation.
Failure to do so can result in death, explosion,
or fire.
You will need
• A location that allows for proper exhaust installation. See
"Venting Requirements."
• A separate 30 amp circuit.
• A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."
• A sturdy floor to support the total dryer weight of 200 Ibs
(90.7 kg). The combined weight of a companion appliance
should also be considered.
A level floor with a maximum slope of 1 in. (2.5 cm) under
entire dryer. (if slope is greater than 1 in. [2.5 cm], install
Extended Dryer Feet Kit, Part No. 279810.) Clothes may not
tumble properly and automatic sensor cycles may not
operate correctly if dryer is not level.