Filter
Top Products
1. Using a 4 in. (10.2 cm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 4 in. (10.2 cm) clamp.
2. Move dryer into final position. Do not crush or kink vent.
Make sure dryer is level.
3. (On gas models) Check to be sure there are no kinks in the
flexible gas line.
Reverse the hinge and hinge cover
1. Place the inner door, screwhead side up, on the work space.
2. Gently pull the plastic cover out and down. This unsnaps the
plastic hinge cover from the inside door assembly.
You can change your door swing from a right-side opening to a
left-side opening, if desired.
Remove the door
1. Place a towel or soft cloth on top of the dryer or work space
to protect the surface.
2. Open the dryer door. Remove the 5 screws that hold the door
hinge on the front panel of the dryer. Loosen, but do not
remove, the screw with the top keyhole opening LAST (2nd
from the top).
\
3. Remove the 4 screws that hold the hinge to the door.
ty
4. Reverse the 2 lane hole screw plugs to the opposite side and
insert in the original screw holes.
3.
4.
5.
Lift and pull forward on the door so that the ecrewhead clears
the keyhole. Remove the door.
Lay the dryer door on a flat, protected surface with the inside
door assembly facing up. Remove the 6 screws to release the
outer door assembly from the inner door assembly, as
indicated below. See illustration. It is important that you
remove ONLY the 6 indicated screws.
%j-i
Lift the inner door assembly off of the outer door assembly.
Set the outer door assembly aside.
1, Hinge Screws
2. Hole screw plugs
5. Move hinge to the other side and reattach.
6. Reverse the plastic cover. Slide it up over the inner door
assembly edge and gently snap into place.
7. Set the inner door assembly aside.
15