Filter
Top Products
29
The following sounds may be heard while the washer is
operating. They are normal.
Clicking:
Door locking mechanism clicks when the door locks and
unlocks.
Spraying or hissing:
Water spraying or circulating during the cycle.
If your washer does not function properly or does not function at all, check the following before you call for service.
Humming or gurgling:
Drain pump is pumping water from the washer at times
during a cycle.
Splashing:
Clothes tumbling in the drum during the wash and rinse
cycles.
TROUBLESHOOTING GUIDE
NORMAL SOUNDS YOU MAY HEAR
BEFORE CALLING FOR SERVICE
Problem Possible Cause Solutions
Rattling and clanking
noise
Foreign objects, such as keys, coins, or safety
pins, may be in drum or pump.
Stop washer, check drum and drain lter for
foreign objects. If noise continues after washer is
restarted, call for service.
Thumping sound Heavy wash loads may produce a
thumping sound.
Washer load may be out of balance.
Washing shoes or tightly tangled clothes.
This is normal. If sound continues, washer is
probably out of balance. Stop and
redistribute wash load.
Pause the cycle and redistribute the load
after the door unlocks.
Vibrating noise Shipping bolts and/or packaging materials
were not removed.
Wash load may be unevenly distributed in
the drum.
Not all leveling feet are resting rmly and
evenly on the oor.
Floor not rigid enough.
See the UNPACKING AND REMOVING SHIP-
PING BOLTS section in the installation require-
ments.
Pause the cycle and redistribute the load after
the door unlocks.
See Leveling the Washer in the Installation
Instructions.
Make sure that the oor is solid and does
not ex. See Flooring in the Installation
Requirements.
Water leaking around
washer
Inlet hose connection is loose at tap
or washer.
House drain pipes are clogged.
Drain hose has come out of drain.
Drain hose is not inserted far enough.
Door glass is dirty.
Check hoses. Check and tighten hose
connections.
Unclog drain pipe. Contact a plumber if
necessary.
Tie drain hose to inlet hose or standpipe to
prevent it from coming out during drain. It
should be inserted about 8-12 inches into
the standpipe.
Inspect door glass periodically to make
sure there is no buildup of residue or other
foreign matter. Follow cleaning instructions.
Excessive sudsing Too much detergent or incorrect detergent.
Only use detergent with the High-
Eciency (HE) logo. See Detergent
Use in the How to Use section.