Filter
Top Products
The display shows:
Check if...
BEFORE CALLING FOR SERVICE (cont.)
I # #I-u,:|
Then...
Load is too small. Add 1 or 2 similar itemsto help balance the load.
Load is out of balance. Pause the cycle and redistribute the load after the door unlocks.
The display shows: I _L'_-I
Check if...
Control error.
The washer has an imbalance detection and correction system. If
individual heavy articles are loaded (bath mat, bath robe, etc.) and
the imbalance is too great, the washer will make several attempts to
restart the spin cycle. Ifan imbalance is still detected, the washer wilt
stop and the error code wilt be displayed.
Then...
Unplug the washer and wait 60 seconds. Reconnect power and try
again. If the error reappears, call for service.
The display shows: r J- |
I-I--
Check if...
Water level is too high due to a faulty water valve.
The display shows: n_-
I-I--
Check if...
The water level sensor is not working correctly.
The display shows: n n-
LL-"
Check if...
Thermal overload protectioncircuit in the motor has been
tripped.
The display shows: I PF
Check if...
A power failure hasoccurred.
Then...
Close the water taps, unplug the washer, and call for service. [
I
Then...
Close the water taps, unplug the washer, and call for service. [
I
Then...
Allow the washer to stand for 30 minutes to allow the motor to coot;
then restart the cycle. If the LE error code persists, call for service.
Then...
If the power to the washer has been interrupted during a cycle, the
"PF" error code wilt be displayed the next time the washer is turned
ON. This wilt alert you to the fact that the previous cycle may not
have been completed. Select any cycle to clear the error code and
use the washer.
28