Filter
Top Products
To use washer again:
1. Flush water pipes,
2. Reconnect water inlet hoses to faucets.
3. Turn on both water faucets.
E_ectrica_ Shock Hazard
P_ug into a grounded 3 prong outlet.
Do not remove ground prong,
Do not use an adapter,
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrica_ shock,
To transport the washer:
1. If washer will be moved during freezing weather, put in 1 qt
(1 L) of R.V.-type antifreeze in the drum. Run washer on a
Drain & Spin cycle.
2. Unplug the power cord.
3. Disconnect the drain hose from the drain system and attach
to rear panel clips,
4. Shut off both water faucets,
5. Disconnect the water inlet hoses from faucets, then drain the
hoses and clip them to the rear panel of the washer.
6. IMPORTANT: Call service. Do not reuse transport bolts. Unit
must be transported in the upright position. To avoid
suspension and structural damage, your machine must be
properly set up for relocation by a certified technician.
Reinstalling the washer
1.
2.
Follow the "Installation Instructions" to locate, level and
connect the washer.
Run the washer through the Normal/Casual cycle to clean the
washer and remove the antifreeze, if used. Use only HE High
Efficiency detergent. Use 1/4the manufacturer's
recommended amount for a medium sized load.
4.
5.
Plug in washer or reconnect power.
Run the washer through the Normal/Casual cycle. Use only
HE High Efficiency detergent. Use 1/4the manufacturer's
recommended amount for a medium sized load.
TROUBLESHOOTING
First try the solutions suggested here to possibly avoid the cost of a service call...
Error codes
When all cycle indicator lights are blinking, see which status light
is also illuminated and then check the list below for potential
problem and troubleshooting checks, An error code may be
shown in the Estimated Time Remaining display (on some
models),
• "Rinse" and "Clothes Clean" Status Light illuminated or
"F20" on display (on some models) (Water Inlet Problem--
no water or insufficient water supply)
Select PAUSE/CANCEL twice to cancel the cycle. Unplug
washer or disconnect power.
Check the following:
Are water faucets completely turned on?
Are screens at inlet hose connection to washer clogged? Are
water inlet hoses kinked?
Are water inlet hoses frozen?
Electrical Shock Hazard
Plug into a grounded 3 prong out_et,
Do not remove ground prong,
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or eiectrica_ shock.
Plug in washer or reconnect power, Re-select cycle and press
START. Ifthe problem remains, call for service.
21