Filter
Top Products
9
To Operate Your Kambrook
Steam Station
• Remove the water tank from the
steam station base by grasping
the handle at the front of the
water tank and pulling forward
until the tank clears the base.
Pull upwards on the anti-scale
filter cartridge fitted to the top
of the water tank to remove.
• Fill the water tank with normal tap
water; do not exceed the MAX
water level marking on the tank.
NOTE: Your steam station
is designed to work with
untreated tap water.
• Fit the anti-scale filter cartridge
back into place and slide the
water tank into the base of the
steam station making sure that
it is properly fitted.
• Plug the power cord into a 230V
or 240V power point and switch
on. The Power Indicator Light at
the back of the steam station
base will illuminate.
• Turn the Thermostat Control
located on the iron to the desired
temperature or in accordance
with the Textile Labelling Code;
wait for the non-stick soleplate
to heat up. When it reaches the
correct temperature, the Iron
Thermostat Light will go out,
then cycle on and off as the
thermostat operates to maintain
the temperature.
NOTE: Always place your iron
with the non-stick soleplate
sitting correctly on the Iron Rest
provided. The Iron Rest is fitted
with non-slip inserts and has
been designed to withstand
high temperatures.
WARNING: The soleplate
of the iron must be
placed on the Iron
Rest correctly to avoid
damaging the Steam
Station Base. Do not sit
the soleplate too forward
on the Iron Rest so it sits
over the edge of the Iron
Rest; ensure the soleplate
is sitting correctly on the
non-slip inserts only.
IMPORTANT: Do not
use tumble dryer
condensate, scented
water softened water
refrigerator condensate,
battery water, air
conditioner condensate,
distilled water or
rainwater as they contain
organic waste or mineral
components that are
concentrated by heat
and cause spitting,
brown staining
or premature aging of
your appliance.