John Lewis JLWM 1203 Washer/Dryer User Manual


 
9
When discharging into a standpipe ensure that the top
of the standpipe is no more than 90cm (35.4'') and no
less than 60cm (23.6'') above floor level.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece is
available from your local Service Force Centre.
The joining piece must have an internal diameter of
18mm.
If your drain hose looks like this (see below) you do
not require the “U” piece”. Just push the hose firmly
into the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before, remove
any blanking plug that may be in place.
P1212
Min. 60 cm (23.6)
Max. 90 cm (35.4)
3 pin
HEC0012
30 cm (12")
38 mm (½)
standpipe
diameter
HEC0013
½
Push the drain hose onto the spigot and secure with a
clip if required, ensure a loop is formed in the drain
hose (see diagram) to prevent waste from the sink
entering the washing machine.
Important
Before connecting the machine to new pipework or to
pipework that has not been used for some time, run off
a reasonable amount of water to flush out any debris
that may have collected in the pipes.
Levelling
Level the washing machine by raising or lowering the
feet. The feet may be tight to adjust as they incorporate
a self locking nut, but the machine MUST be level and
stable.
If necessary, check the setting with a spirit level.
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, (see note on
positioning), noise and displacement of the machine
during operation.
HEC007S
P1198
Loop
P1197
132972411.qxd 07/12/2007 11.16 Pagina 9