John Lewis JLWM 1203 Washer/Dryer User Manual


 
13
Programme options buttons
Depending on the programme, different options can be
selected together. These must be selected after
choosing the desired programme and before pressing
the “Start/Pause” button.
When these buttons are pressed, the corresponding
pilot lights illuminate. When they are pressed again, the
pilot lights go out.
If an option which is not compatible with the set
wash programme is selected, the red Start/Pause
light flashes 3 times and the message Err is
displayed for about 2 seconds.
4 “Prewash / Rinse hold /
Stain” button
Press this button repeatedly, to select only one of the
following options:
Prewash: select this option if you wish your laundry
to be prewashed before the main wash
(not available for Wool and “30 Minute wash”).
The prewash ends with a short spin in programmes
for cotton and synthetic fabrics, whereas in the
programme for delicate fabrics the water is only
drained. This option can be selected for heavily soiled
laundry.
• “Stain”: select this button if you wish to add a stain
phase to the washing of heavily soiled laundry. Pour
a stain removing detergent into the compartment
marked .
This function is available in cotton, synthetic
and delicates programmes with a temperature
of 40° or higher.
The washing time will be prolonged by few minutes.
Rinse hold”: when you choose this option, the
machine will not drain the water of the last rinse, this
will ensure the minimum of creasing to laundry.
At the end of the cycle, the light corresponding to
the option “Rinse hold” and the “Door lock” light
are on, the “Start/Pause” button light goes out and
the display shows a flashing «
0».
The door cannot be opened because the water must
be drained.
To empty out water there are 2 possibilities:
- Select
Drain” programme and press the
Start/Pause” button : the water is emptied out
without spinning.
- Select “Spin” programme. Select the spin speed by
means of the relevant button and then press the
Start/Pause” button. The water is emptied out
and the laundry is spun at the selected spin speed.
Attention!
Before selecting the
Drain” programme or “Spin
programme the selector dial must first be turned to
the «Off» position.
5 “Intensive” button
This option can be selected for heavily soiled cottons. If
you press this button the washing intensity will be
increased and the washing time will be prolonged by
few minutes depending on the selected temperature.
This option is not available for “Economy”,
Synthetics, Wool/Hand wash, Delicates and “30
Minute wash” programmes and in combination with
Quick” option.
6 “Extra rinse” button
T
his option can be selected with all programmes,
except the Wool programmes and “30 Minute wash”.
The machine performs some additional rinses.
This option is recommended for people who are
allergic to detergents, and areas where the water is
very soft.
7 “Quick” button
This option can be used for lightly soiled (not for Wool,
Hand wash programmes, “30 Minute wash” and
Economy programmes) in order to obtain a good
washing result in a short time. The washing time will be
reduced according to the type of fabric and the selected
temperature (Max recommended load = 3 kg for
Cottons and 1 Kg for Synthetics). “Quick” cannot be
used in combination with the “Intensive” option.
Child lock
This function works in two different ways:
If enabled before the «Start/Pause» button is
pressed, it prevents the machine from being
started.
If enabled after pressing the «Start/Pause»
button, it prevents any changes being made to the
programmes or options selected.
To enable or disable this function, press the «Spin»
and «Prewash» buttons simultaneously for approx
6 seconds until the icon appears on or
disappears from the display.
132972411.qxd 07/12/2007 11.16 Pagina 13