John Lewis JLWM 1203 Washer/Dryer User Manual


 
14
8 Display (Wash time)
The following pieces of information are shown on the
display:
Duration of washing programme in hours and
minutes, after you have selected a programme.
While the programme is running (after you have
pressed the Start/Pause button), the displayed time
value decreases by one unit every minute.
The washing machine has completed the
programme: this is indicated by a flashing zero.
The “Door lock” pilot light and the Start/Pause light
go out and the door can be opened.
The washing machine has stopped with water
in the tub, at the end of the “Soak” or a
programme with the “Rinse hold” option: this is
indicated by a flashing zero. The Start/Pause light
goes out but the “Door lock” pilot light is still on.
The door cannot be opened.
If your laundry is not removed during 10 minutes
after the programme has finished, all pilot lights and
the display will switch off and the energy saving
system will be enabled. Only the green Start/Pause
light flashes to indicate that the appliance has to be
switched off.
Delay start, a time value indicated in hours and
minutes and selected using the delay start button.
0
2.00
2.00
The delay time (20 hours max) is displayed for 3
seconds, then the duration of the selected
programme reappears.
After you have pressed the Start/Pause button, the
countdown is updated every hour, and, for the last
hour, every minute.
An incorrect option selection has been made:
this is indicated by the message Err for about 2
seconds when a function incompatible with the
current programme is selected.
An alarm code indicates a fault with the machine
(see the relevant chapter).
9 Start/Pause button
To start the selected programme, press the
Start/Pause button; the green pilot light stops
flashing.
If you have selected a delay time, the countdown will
begin and will be shown on the display.
To interrupt a programme which is running, press
the Start/Pause button: the green pilot light starts
to flash.
To restart the programme from the point at which
it was interrupted, press the Start/Pause button
again.
E20
132972411.qxd 07/12/2007 11.16 Pagina 14