John Lewis JLWD1404 Washer/Dryer User Manual


 
7
4 “Option” buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing
the desired programme and before depressing the
“”Start/Pause” button.
When these buttons are pressed, the corresponding
pilot lights illuminate. When they are pressed again, the
pilot lights go out.
If an incorrect option is selected, the pilot lights flash
for about 2 seconds and the message Err is displayed.
Press these buttons to select the following options:
• “Prewash”: select this option if you wish your
laundry to be prewashed before the main wash (not
available for Wool and “30 Minute wash” and not
recommended with the programme Duvet 40°).
The prewash cycle ends with a short spin at 650 rpm
in programmes for cotton and synthetic fabrics,
whereas in the programme for delicate fabrics the
water is only drained. This option can be selected for
heavily soiled laundry.
• “Quick”: select this option for laundry that is only
slightly soiled in order to obtain a good wash result in
a short time.
This option is not available with the Wool
programmes, the Energy saving programmes
Economy” and “30 Minute wash.
The washing time will be reduced according to the
type of fabric and the selected temperature.
• “Extra rinse”: this option can be selected with all
programmes, except the wool programmes and “30
Minute wash”. The machine performs 4 rinses
instead of 3.
This option is recommended for people who are
allergic to detergents, and areas where the water is
very soft.
5 “Automatic Dry” button
This button allows you to choose the required degree
of drying for cottons and synthetics:
- Extra dry (only for cottons)
- Store dry (cottons and synthetics)
- Iron dry (only for cottons)
The drying time is automatically adjusted by the
machine: the laundry will be dried to the selected
degree of dryness.
6 “ Time dry” button
If you wish to carry out a timed programme instead of
an electronic programme push the button until the
drying time you want appears in the display according
to the fabrics (cotton or synthetics) you have to dry.
For Cottons you can select a drying time from 10
minutes to 130 minutes.
For Synthetics you can select a time from 10 minutes
to 100 minutes.
7 “Delay start” button
This button makes it possible to delay the starting of
the programme by up to 24 hours. The delay you have
selected is shown on the display for about 3 seconds;
afterwards, the duration of the programme reappears.
You must select this option after you have set the
programme and before you press the Start/Pause
button.
The time value shown on the display will decrease by
one unit every hour.
You can change the delay time at any moment,
before you press the “Start/Pause” button.
If you have already pressed the “Start/Pause” button,
and you wish to change or cancel the delay time,
proceed as follows:
• set the machine to PAUSE by pressing the
“Start/Pause” button;
• press the “Delay start” button until the display shows
the desired delay time or
• press the “Delay start” button once, to erase the
delay time. The display will indicate “
0 h”.
• press the “Start/Pause” button again.
Important!
The door will be locked throughout the delay time.
If you need to open the door, you must first set the
washer-dryer to Pause by pressing the Start/Pause
button. After you have closed the door, press the
Start/Pause button again.
8 “Start/Pause” button
This button has three functions:
Start: after you have selected the desired programme
and options, press this button to start the washer-
dryer. The light above the button will stop flashing
and remain lit.
If you have selected a delay time, the countdown will
begin and will be shown on the display.