Filter
Top Products
Drying cycle complete /
removing laundry
Once the drying cycle is complete, the
display shows the anti-crease icon and
flashing "0" as well as warning lamps: Filter
and Full tank. If the Alarm button has been
pressed, an acoustic signal sounds
intermittently for about one minute.
The drying cycles are automatically
followed by an anti-crease phase
which lasts around 30 minutes. The
drum rotates at intervals during this
phase. This keeps the laundry loose
and free of creases. The laundry can
be removed at any time during the
anti-crease phase. (The laundry
should be taken out towards the end
of the anti-crease phase at the latest
to prevent creases from forming.) If
Anti-crease function has been
selected, the anti-crease phase is
lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best
to use a damp hand for this purpose.
(See “Maintenance and cleaning”
chapter.)
3. Remove laundry.
4. Turn the programme selector to Off.
Important! After each drying cycle:
- Clean the micro-fine filter and fine
filter
- Drain the condensed water container
(See chapter “Maintenance and
cleaning ”.)
5. Close the door.
Drying rack
Special equipment for gentle drying washable
woollens and sport shoes. Incomparable for
drying wet woollens - eliminated movement,
protection from matting.
For drying rack unpacking see
Installation chapter.
15