Filter
Top Products
16
Clean it with a brush and rinse it under the shower if
necessary.
Also clean the outside, removing all fluff.
Clean the rubber seal round the condenser cabinet and in
the inner part of the small door with a damp cloth.
Important! Do not use pointed objects or utensils to
clean the spaces between the plates, as this could damage
the condenser and make it permeable.
Re-fit the condenser, turn the red stops upwards and
close the door.
Do not use this appliance if the
condenser has not been fitted.
Emptying the water reservoir
Water extracted from the laundry condenses inside the
machine and is collected in a reservoir.
The reservoir must be emptied after each drying cycle to
ensure efficient operation when the machine is next used.
The FULL TANK light reminds you to perform this
operation.
Proceed as follows:
• Pull out the reservoir
• Turn it upside down and let water empty
• Re-fit the reservoir
P1157
P1156
P0639
The reservoir must be re-inserted correctly.
If this is not done the pilot light FULL TANK comes on
during next drying and the programme stops, leaving the
laundry damp. The buzzer will sound.
After inserting the reservoir the START/PAUSE button
has to be depressed again to allow the programme to
continue.
Handy tip: The condensed water may be used in a
steam iron or to top up a battery, etc. In this case it must
be filtered (e.g. through a coffee filter).
Cleaning the drum
When your laundry does not reach the desired degree of
dryness, in other words, when it turns out either too dry
or too damp,we advise you to clean the inside of the
drum with a cloth soaked with vinegar.
This will eliminate the slight patina that has formed in the
drum (due to residues of detergent and softeners used in
the washing, and to the lime contained in the water),
which prevents the probes from detecting the correct
degree of dryness.
125980753.qxp 2005-12-05 07:58 Page 16