Filter
Top Products
10
Every time the button is pressed, the time is increased by
30 minutes, until the display shows a delay of “2 hours”.
After this, the delay is displayed hour by hour.
The minutes or hours of delay that have been selected
are displayed for 2 seconds, then the display shows the
duration of the previously selected programme.
The countdown begins after you have pressed the
START/PAUSE button.
To cancel the delay time, during the drying phase the
START/PAUSE button to set your appliance to pause and
then press the DELAY START button until the display
indicates 0’. Then press the START/PAUSE button again.
When the delay is cancelled, the display shows the
duration of the programme.
During the delayed start, it is not possible to change the
programme or the delay time that have been selected. To
do this, you must first switch off the machine by setting
the programme selector dial to “Off”. Select the new
programme, the options and the delayed start, then press
the START/PAUSE button.
If you wish to add more laundry while the machine is
performing the countdown, simply open the door. When
you close the door, press the START/PAUSE button again
to cause the countdown to be resumed.
7 Display
The display shows the following information:
• duration of selected programme
• delayed start
• end of programme
• incorrect option selection
• alarm code
• Duration of selected programme
After you have selected the programme, its duration (in
hours and minutes) appears on the display. It is calculated
automatically on the basis of the maximum load accepted
for each type of fabric and of the required degree of drying.
When the programme starts, the remaining time is
displayed every 5 minutes.
• Delayed start
If you have selected a delay time by means of the
relevant button, the display shows it for 2 seconds; then
it shows the duration of the previously selected programme.
1.20
The countdown is displayed every 30 minutes until it
displays “90 minutes” and then hour by hour.
• End of programme
A flashing zero indicates the end of the programme
and it is displayed after the “anti-creasing” phase.
• Incorrect option selection
If you select an option that is not compatible with the
programme you have selected, the display shows Err
(error).
This code will reappear during the execution of the
programme if you press one of the option buttons.
• Alarm code
In the case of a functional problem, the display shows
an alarm code (e.g. E21). See page 13 for more detailed
information.
E21
0
3
125980753.qxp 2005-12-05 07:58 Page 10