Filter
Top Products
9
Using the washing machine
Before the first wash, run a cotton cycle at 90°C,
without any laundry in the machine, to remove any
manufacturing residue from the drum and tub. Pour 1/2
a measure of detergent into the main compartment of
the dispenser drawer and start the machine.
WASHING 6 KG OF WHITE COTTON AT 90°C
Suppose you have 6 kg of laundry to wash. It is white
cotton and is suitable for high temperature washing.
Load the laundry
Open the door.
Place the laundry in the
drum, one item at a time,
shaking them out as much
as possible. Close the
door.
Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required and pour it into
the main wash compartment .
P0004
If you wish to carry out the prewash, a soak programme
or a stain phase, pour detergent or stain remover into
the appropriate compartment marked .
Important!
Do not use normal
detergent for the “Stain”
option, always use a
STAIN remover.
Measure out the fabric softener
If required, pour fabric
softener into the
compartment marked ,
without exceeding the
«MAX» mark.
Close the drawer gently.
Switch the machine on
Turn the selector dial to any programme to switch the
P0006
P0005
Child lock
This function allows you to leave the appliance
unsupervised and not to worry that children might
be injured by or cause damage to the appliance.
This function remains enabled also when the
washing machine is not working.
There are two different ways to set this option:
If enabled before the «Start/Pause» button is
pressed, it prevents the machine from being
started.
If enabled after pressing the «Start/Pause»
button, it prevents any changes being made
to the programmes or options selected.
To enable (or disable) this function, press the
«Spin» and «Option» buttons simultaneously for
2
1
First use
approx 6 seconds until the icon appears on (or
disappears from) the display.
Acoustic signal
The machine is provided with an acoustic device,
which sounds in the following cases:
● At the end of the cycle
● If there is a fault
By pressing “Prewash” and the “Quick” buttons
simultaneously for about 6 seconds, the acoustic
signal is deactivated (except if there is a fault).
By pressing these 2 buttons again, the acoustic signal
is reactivated.