John Lewis JLBIWM 1402 Washer/Dryer User Manual


 
7
Rinse hold: when you choose this option, the
machine will not drain the water of the last rinse, this
will ensure the minimum of creasing to laundry.
At the end of the cycle, the lights corresponding to the
options “Rinse hold” and the “Door lock” are on,
the “Start/Pause” button light goes out and the
display shows a flashing «
0».
The door cannot be opened because the water must
be drained.
To empty out water there are 2 possibilities:
- Select Drain programme and press the
Start/Pause” button : the water is emptied out
without spinning.
- Select Spin programme. Select the spin speed by
pressing the relevant button and then press the
Start/Pause button. The water is emptied out and
the laundry is spun at the selected spin speed.
Attention!
Before selecting Drain programme or Spin
programme the selector dial must first be turned to the
«Off» position.
S
TAIN: Select this button if you wish to add a stain
phase to the washing of heavily soiled laundry. Pour a
stain removing detergent into the compartment
marked
.
This function is available for programmes with a
temperature of 40° or higher.
The washing time will be prolonged by a few minutes.
For the compatibility of this option with the washing
cycles, refer to the Chapter «Washing programmes»
4 Prewash button
Select this option if you wish your laundry to be
prewashed before the main wash.
The prewash ends with a short spin in programmes for
cotton and synthetic fabrics, whereas in the programme
for delicate fabrics the water is only drained. This
option can be selected for heavily soiled laundry.
5 Quick button
This option can be used for lightly soiled garments in
order to obtain a good washing programme in a short
time. The washing time will be reduced according to the
type of fabric and the selected temperature.
We recommend that you reduce the load to 3 kg for
Cottons and 1.5 Kg for Synthetics and Delicates.
For the compatibility of this option with the washing
cycles, refer to the Chapter «Washing programmes»
6 Extra rinse button
This option can be selected with all programmes,
except the Wool programmes and “30 Minute wash”.
The machine performs some additional rinses.
This option is recommended for people who are
allergic to detergents, and areas where the water is
very soft.
7 Display (Wash time)
The following pieces of information are shown on the
display:
Duration of washing programme in hours and
minutes, after you have selected a programme.
While the programme is
running (after you have
pressed the Start/Pause
button), the displayed time
value decreases by one unit
every minute.
The washing machine has completed the
programme: this is indicated by a flashing zero.
The
“Door lock” pilot light and the Start/Pause light
go out and the door can be opened.
The washing machine has stopped with water
in the tub, at the end of the “Soak” or of a
programme with the “Rinse hold” option: this is
indicated by a flashing zero. The Start/Pause light
goes out but the “Door lock” pilot light is still on.
The door cannot be opened.
If your laundry is not
removed within 10 minutes
after the programme has
finished, all pilot lights and
the display switch off and
the energy saving system
will be enabled. Only the green Start/Pause light flashes
to indicate that the appliance has to be switched off.
Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time (20 hours
max) is displayed for a few
seconds, then the duration
of the selected programme
reappears.
After you have pressed the
Start/Pause button, the countdown is updated every
hour, and, for the last hour, every minute.
An incorrect option selection has been made:
0
2.00