John Lewis JLBIWM 1402 Washer/Dryer User Manual


 
11
will show a flashing zero. The “Door lock” light is on.
Before starting a new washing phase, it is necessary to
empty the water by selecting the “Drain” programme.
This programme cannot be used for very delicate
fabrics as silk or wool.
Rinse
With this programme it is possible to rinse and spin the
cotton garments which have been washed by hand. The
machine performs 3 rinses, followed by a final long spin
at the maximum speed.
Important!
The spin speed will automatically assume the setting for
cotton items. If required, reduce the speed to the
desired level by pressing the "Spin" button.
Drain
For emptying out the water of the last rinse in
programmes with the “Rinse hold” option or of
Soak” programme. First turn the programme selector
dial to “Off”, then select the “Drain” programme and
press the “Start/Pause” button.
Spin
Separate long spin at the max speed for hand washed
cotton garments. The spin speed will automatically
assume the setting for cotton items. You can reduce
the speed by means of “Spin” button to adapt it to the
fabrics to be spun.
30 Minute wash
This is a complete programme that can be combined
with the following options: “Spin” speed
reduction/None and “Delay start”.
To be used for laundry which is lightly soiled or which
needs freshening up.
Max. load 2 kg.
Washing temperature 30 C.
Programme duration 30 minutes.
Final spin speed 700 rpm.
Off = Reset / Switching the machine off
To reset a programme or to switch the machine off,
turn the selector dial to “Off”.
A new programme can now be selected.
The level of the water is not high;
If these requirements are met, when you pause the
washing machine, the “Door lock” light goes off and
the door can be opened.
Should it not be possible to open the door, and should
it be absolutely necessary to do so, switch the machine
off by turning the selector dial to “Off”.
After a few minutes, you can open the door.
Pay attention to the level and temperature of
the water in the washing machine!
When you close the door to restart the programme
turn the dial to the previous programme repeating the
options previously selected and press Start/Pause
button.
End of programme
At the end of the programme, the washing machine
stops automatically, the “Start/Pause” button light and
the “Door Lock” light go off, the display shows a
flashing zero
«0». It is now possible to open the door.
If you had selected the “Rinse hold” option, the
Rinse Hold” light and the “Door lock” light remain lit
to indicate that the door is locked and the water must
be drained.
To drain or to spin see paragraph “Rinse hold” on
page 14. Turn the programme selector dial to Reset
«Off» to switch the machine off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
Programme information
Soak
This is a special programme for heavily soiled laundry.
The machine performs a soak of about 40 minutes at
30°C. Pour the detergent for the soak programme into
the compartment marked .
At the end of the soak time the machine will stop
automatically with water left in the tub. The display