Filter
Top Products
20
Problem Possible Causes What To Do
The dishes were not
loaded correctly.
The programme was not
powerful enough.
Not enough detergent was
dispensed.
Item are blocking
the path of spray arms.
See notes in " Loading the Dishwasher Baskets ".
Select a more intensive programme. See" Wash Cycle
Table ".
Use more detergent, or change your detergent.
Rearrange the items so that the spray can rotate freely.
The dishes are not
clean
The filter combination in
the base of wash cabinet
is not clean or is not
correctly fitted. This may
cause the spray arm jets
to get blocked.
Clean and/or fit the filter combination correctly. Clean
the spray arm jets. See "Cleaning the Spray Arms".
Cloudiness on
glassware
Combination of soft water
and too much detergent.
Use less detergent if you have soft water and select a
shortest cycle to wash the glassware and to get them
clean.
Black or gray marks
on dishes
Aluminum utensils have
rubbed against dishes.
Use a mild abrasive cleaner to eliminate those marks.
Unsatis
factory
washing
result
Detergent left in
dispenser cups
Dishes block detergent
cups.
Re-loading the dishes properly.
Improper loading Too little
rinse-aid
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/Refill the rinse-aid
dispenser.
Unsatis
factory
drying
result
The dishes are not
drying
Dishes are removed too
soon.
Wrong programme
selection
Using cutlery with a low-
quality coating
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once the
dishes are barely warm to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short programmes the washing temperature is lower.
This also lowers cleaning performance. Choose a
programme with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
Error Codes
When some malfunctions come on, the appliance will display error codes to warn you:
Codes Meanings Possible Causes
The dry (hase) light flicker
fleetly
Longer inlet time. Faucets is not opened, or water intake is restricted, or
water pressure is too low.
The main(phase) light flicker
fleetly
Overflow. Some element of dishwasher leaks.
WARNING!
If overflow occurs, turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak, the water should be
removed before restarting the dishwasher.