Filter
Top Products
7. Adjust the feet...
Once the machine is in place
10
6. Move the machine into position...
Your machine is heavy so care must be taken when moving
it.
● When moving the machine, take care not to kink or
damage the hoses at the back of machine.
● Please take care not to damage any floor coverings
when moving the machine.
WARNING:
● Do not drag
or lift the
machine by
it’s door.
INSTALLING YOUR
MACHINE
●
The spring on each foot will stop them coming loose.
●
Switch the machine on at the plug socket.
●
When your machine is in its intended
location, make sure that it is level
by turning one or both of the front
feet clockwise until the machine
stands firm and level.
The maximum slope of the table top
must not exceed 2˚.
Your machine may become noisy or move about if it is not
level. If necessary, to level the machine adjust the two front
feet, as follows:
Now that you have successfully
installed your new machine, we
advise that you run it through a
95˚ White Cotton programme
without any laundry and without
any detergent in it.
This will check your installation,
connections and drainage, and
will thoroughly clean the interior
before you carry out an actual
wash programme on your laundry.
NOTE: This will take approximately 2
hours to complete.
Continue reading this book to get
to know the various features of
the machine.
TECHNICAL DETAILS
Models
Dimensions
Capacity
Electric
Connections
Spin Speed
Control
programmes
according to
IEC50229
directive
WD865,WD860
59.5cm wide
85cm high
60cm deep
from 1 to 6kg Wash
from 1 to 5kg Dry
voltage 220/230 Volts 50Hz
maximum absorbed power 1700W
up to 1600rpm
Cotton wash
temperature 60˚C
Wash run with a 6kg load
Dry run with a 1kg load followed
by a 5kg load