Filter
Top Products
Using your appliance
17
IMPORTANT:
- Do not open the door to
stop the appliance.
- Do not try to open the
door while the Door
Locked Indicator light is lit.
Setting a Wash Programme / Starting the appliance
Load the laundry into the appliance and close the door. Load the detergent. Set the required
programme. Turn the Temperature knob to that of the selected programme.
Press on the ‘On/Off’button.
The On/off Indicator light (L) will start to flash. After a short time the selected programme will
be accepted and the light will stop flashing and the wash cycle will begin.
After washing and/or drying
Press the ‘On/Off’button to switch off the appliance. The Operating Indicator light will go out.
Wait until the Door Locked indicator light goes out before opening the door, to allow the safety
device to disconnect. Unload the laundry.
Cancelling or changing the programme
Should you wish to interrupt the programme in progress or set a new one,turn the Programme
Selection knob to select one of the symbols ● (Stop/Reset). After a short time the cancellation
will be accepted,the On/Off Indicator light will flash - you can then either turn the appliance
off or select another programme.
Delayed start
Use the Programme Selection knob to delay the start of the selected wash programme:
Select one of the delay time positions (12,9, 3 or 1 hours with Washing Machine Model BWM12
and 12,9 and 3 hours with Washer Dryer Model BWD12),press the On/Off button wait a short
time until the On/Off indicator light stops flashing to show the setting has been accepted.
You can now select the programme required.
The On/Off indicator light has a particular flashing motion (2 seconds on and 4 seconds off) to
indicate that a delayed start has been set.
During the ‘delay’you can open the door and change the wash load,should you wish to do so.