Filter
Top Products
EN
16
The machine is noisy.
The machine wont spin properly.
The machine leaks from the
dispenser.
The machine leaks (other than
dispenser).
The Phase in Progress indicator
lights flash rapidly at the same
time as the ON/OFF indicator light.
The machine smells.
The machine door cannot be
opened.
Door Seal damaged at the
bottom.
The water level is too low when
the machine is washing.
The word 'dON' appears
intermittently in the display
window and the drum slowly turns.
The machine just 'beeps' when a
programme or option is selected
(Child Lock Symbol is lit).
There is too much foam.
After completing the
programme, or before starting a
programme, the machine has
turned itself off (no lights).
General.
There will always be some motor, pump and drum noise during spin.
Out of Balance detected when attempting to go into a spin cycle - If this
happens the machine will continue to try to repeat the distribution of the
load required before the machine will go into higher spin speeds - This will
increase the programme time accordingly. This is a safety feature to
prevent damage. Out of Balance can be caused by washing a single heavy
item (eg duvet, quilt, etc). - Try the programme again using a different load.
The dispenser drawer is blocked with detergent and requires cleaning.
The water pressure is too high and requires turning down - turn down
the tap on the water supply pipe slightly and try again.
The machine is tilting forwards - It must be level when in its final position.
The fill hose is loose, check both the cabinet and tap ends.
The fill hose is tight but still leaks, if so replace the rubber washers, or
the fill hose is missing the rubber washer.
The drain hose is not fixed in properly.
Switch off the machine and unplug it, wait for approximately 1 minute
and then switch it back on again If the problem persists contact the
Technical Assistance Service.
The machine requires a service wash. Run a 90 degree wash cycle with
detergent and no laundry.
The door will not open until the door lock indicator light goes out
shortly after the program has finished.
If there is no power to the machine you need to perform the manual
unlocking procedure.
The door seal has drainage holes at the bottom - This is normal.
The water level is correct if it can be seen at the bottom of the door.
To exit, switch machine off, then press and hold 'ON/OFF' and 'START/
PAUSE' buttons simultaneously for 3 seconds Note the machine will
need the language resetting.
Deactivate the Child Lock feature by pressing and holding in the 'CHILD
LOCK' button for 2 seconds.
The detergent is not suitable for machine washing (it should display the
text 'for washing machines' or 'hand and machine wash' or the like).
Too much detergent was used - less detergent is required in soft water.
To comply with new energy saving regulations the machine is fitted
with an automatic standby system. Press 'ON/OFF' button for 3
seconds to activate the machine, it can then either be switched off or
a new programme selected.
Your washing machine contains sensors that monitor progress during
the wash cycle (eg: Water Levels, Temperatures, Out of Balance
loads, Wash time/progress). Normally, if your machine successfully
completes the cycle, there is unlikely to be anything wrong!