Filter
Top Products
6
GB
Programmes and
Option Modifiers
Option modifiers
Selecting options and their function
●
Wash Enhance:
Use this option to select a more intensive wash programme for the cotton 60˚C and cotton 40˚C for more heavily
soiled items. Additionally, use this option on the machine wash wool programme to select the special Handwash
wool programme for wool items that are not marked as machine washable. This cycle has been approved by
Woolmark for the Platinum Care award.
●
Reduced Creases:
Selecting this option will run the wash programme with a more gentle action and lower spin speed, in addition to
carrying out an additional rinse to ensure your laundry has fewer creases and will require less ironing.
●
Rinse Hold:
Selecting this option will pause the cycle in the final rinse with the fabric conditioner keeping the laundry fresh
until you are ready to complete the programme. The Rinse Hold option light will flash to indicate the cycle is
paused. The machine will stay in this state, tumbling the load occasionally until either the START/CANCEL button
is pressed or the Rinse Hold button is pressed again to continue the cycle.
●
Mini Load:
Use this option for smaller loads less than the capacity listed for the material and programme type (see
Programmes Table). This option reduces water consumption and washing time, saving energy when washing
smaller loads.
●
Time Delay:
Use this option to delay the programme start by up to 24 hours. The LCD display will show the delay chosen.
Each press of the button increases the Time Delay in increments of 1 hour. If you press the button again after 24
shows in the display the machine will reset the Time Delay and show ‘OFF’ in the display, pressing the button
after this will start the Time Delay selection from 1 hour.
Once the countdown reaches zero the programme will start.
●
Variable Temperature:
Use this option to reduce the wash temperature below the maximum for the programme you have chosen.
- Each press of the button will reduce the wash temperature by either 5˚C or 10˚C.
The new wash temperature will be shown in the LCD display.
If you press again after ‘OFF’ has been displayed, the machine will revert to the original higher temperature.
●
Variable Spin Speed:
Use this option to reduce the spin speed below the maximum for the programme you have chosen.
- Each press of the button will reduce the spin speed. The new spin speed will be shown in the LCD display.
If you press again after ‘OFF’ has been displayed, the machine will revert to the original higher spin
speed.
●
Extra Rinse:
Use this option for people with sensitive skin, to add a rinse to your selected wash programme. Press the ‘Rinse’
option button once and ‘Extra Rinse’ will illuminate on the LCD display. Press the ‘Rinse’ button again to cancel.