Filter
Top Products
10
7) WASH TIME
When a programme is selected the relevant indicator will light up to show the minimum
possible wash time.
Selecting a greater time using the special button will cause the corresponding indicator to light up.
“SPIN SPEED” button
The spin cycle is very important to remove as much water as possible from the laundry without
damaging the fabrics. You can adjust the spin speed of the machine to suit your needs.
By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle
can be cancelled.
To reactivate the spin cycle press the button until you reach the spin speed you would like to set.
To prevent damage to the fabrics, it is not possible to increase the speed over that which is
automatically suitable during the selection of the program.
It is possible to modify the spin speed without to pausing the machine.
Note:
The machine is fitted with a special electronic device, which prevents the spin cycle should
the load be unbalanced.
This reduces the noise and vibration in the machine and so prolongs the life of your
machine.
I
11
“DIGITAL” Display
The display’s indicator system allows you to be constantly informed about the status of the
machine:
1) WASH TEMPERATURE
When a programme is selected the relevant indicator will light up to show the recommended
wash temperature. The Temperature button can be used to decrease or increase the
temperature of your chosen wash cycle. Each time the button is pressed, the new
temperature level is shown on the Wash Temperature Indicator.
2) DOOR LIGHT
Once the START/PAUSE button has been pressed the light first flashes then stops flashing
and remains on until the end of the wash. 2 minutes after the end of the wash the light goes
off to show that the door can now be opened.
3) SPIN SPEED
Once the programme has been selected, the maximum spin speed allowed for that
programme appears on the display. Pressing the spin button will reduce the speed by 100
rpm each time the button is pressed. The minimum speed allowed is 400 rpm, or it is
possible to omit the spin by pressing the spin button repeatedly.
4) DELAY START LIGHT
This flashes when delay start has been set.
5) CYCLE DURATION
When a programme is selected the display automatically shows the maximum cycle duration
for a full load, which can vary, depending on the options selected.
6) KG Mode Indicator
Available on Cotton and Synthetic cycles, during the first 4 minutes of the cycle the intelligent
sensor will weigh the laundry and adjust the cycle time, water and electricity consumption
accordingly.
L
3
4 6
{
{
{
1
5
7
{
PROGRAMME selector with "OFF" position
When the programme selector is turned the
display lights up to show the settings for the
programme selected.
N.B. To switch the machine off, turn the
programme selector to the “OFF”
position.Today, most detergents have been
improved to wash efficiently at lower
temperatures, therefore we have set the default
temperature settings of each programme to a
lower level, saving electricity and reducing the
carbon footprint of your machine.
You can select an high temperature by pressing
the temperature button.
Please refer to the programme guide for the
maximum temperature to which each
programme can be set.
Press the "Start/Pause" button to start the selected cycle.
Once a programme is selected the programme selector remains stationary on the selected
programme till cycle ends.
Switch off the washing machine by turning the selector to "OFF".
Note:
The programme selector must be returned to the "OFF" position
at the end of each cycle or when starting a subsequent wash
cycle prior to the next programme being selected and started.
N
Buttons indicator light
These light up when the relevant buttons are pressed.
If an option is selected that is not compatible with the selected programme then the light on
the button first flashes and then goes off.
O
“WASH TIME” button
By selecting this button (active only on COTTON and MIXED FIBRES programmes) there is
a choice of 3 levels of wash intensity, depending on how much the fabrics are soiled.
Once the programme has been selected the indicator light will automatically show the
minimum level required for that programme. Pressing the button increases the duration of the
wash cycle, and adjusts the wash settings accordingly. For example: Using this button on
the Rapid Wash cycle will enable you to select either a 14, 30 or 44 minute wash cycle.
M
2