Filter
Top Products
6
Description of controls
Door open button A
"Door Security" indicator light B
"Start/Pause" button C
"Fast Iron" button D
Wash temperature button E
"Delay Start" button F
"Sensitive Care" button G
"Stain Blaster" button H
"Spin Speed" button I
Digital display L
Wash time button M
Programme selector with “OFF” position N
Buttons indicator light O
Detergent drawer P
Door open button
Press the button to open the door.
Important:
a special safety device prevents the door from opening at the end of the wash/spin cycle. at
the end of the spin phase wait up to 2 minutes before opening the door.
A
7
“DOOR SECURITY” indicator light
The “Door Security” indicator light is illuminated when the door is fully closed and the machine is ON.
When "Start/Pause" is pressed on the machine with the door closed the indicator will flash
momentarily and then illuminate.
If the door is not closed the indicator will continue to flash.
Aspecial safety device prevents the door from being opened immediately after the end of the cycle.
Wait for 2 minutes after the wash cycle has finished and the “Door Security” light has gone out
before opening the door. At the end of the cycle turn the programme selector to "OFF" .
B
NOTE:
FEW SECONDS AFTER THE START THE WASH CYCLE WILL
BEGIN. DURING THE FIRST 4 MINUTES OF THE WASH CYCLE,
THE KG MODE (ACTIVE ONLY ON COTTON AND SYNTHETICS
PROGRAMMES) WILL WEIGH THE CLOTHES AND UPDATE THE
MAXIMUM WASH TIME REMAINING ON THE DISPLAY EVERY
FIVE SECONDS UNTIL THE WEIGHT HAS BEEN DETERMINED.
WHILE THIS FUNCTION IS OPERATING THE “Kg MODE”
INDICATOR IS ON.
“START/PAUSE” button
Press to start the selected cycle .
Changing the settings after the programmes has started (PAUSE)
Press and hold the “START/PAUSE” button for about 2 seconds, the flashing lights on the
options buttons and time remaining indicator will show that the machine has been paused,
adjust as required and press the “START/PAUSE” button again to cancel the flashing lights.
If you wish to add or remove items during washing, wait 2 minutes until the safety device
unlocks the door.
When you have carried out the manoeuvre, close the door, press "Start/Pause" button and
the appliance will continue working where it left off.
CANCELLING THE PROGRAMME
To cancel the programme, set the selector to the OFF position.
Select a different programme.
Re-set the programme selector to the OFF position.
C
P
L
O
I
M
H
G
FEDC A N
B