HoMedics PS-250 Iron User Manual


  Open as PDF
of 12
 
6 7
Instructions for Use
1.Removethewatertankfromtheunitbygraspingthehandleand
turningupsidedown.Unscrewthecapfromthebottomofthewater
tank.Holdthetankundercoldrunningwaterandfilltothedesired
level(Fig.6).DONOTfillpastthe45min.fillline.Whenyouhave
finishedfillingthetankscrewthecapbackonandturnover(Fig.7).
Placewatertankbackintounitandmakesureitissittingproperly&
securelyinthecavity.
NOTE:Onlyfillthewatertankwithcoldwater,DONOTuseHOT
water.
2.Plugthesteamercordintoa120VACelectricaloutlet.
3.TurntheOn/OffswitchtotheOnposition.Theswitchwilllight
toindicatethatthegarmentsteamerison.Steamwillemitin45
secondsfromthenozzle.
4.Hangthegarmentontothehangerattachment(Fig8).Steamthe
garmentinanup/downmotionstartingfromthetopofthegarment
tothebottom.Alwayskeepthehoseandnozzleelevatedabovethe
watercontainer.
5.Thisunithasaresetbutton(Fig.10).Whentheunitrunsoutof
wateritwillautomaticallyshut-offtoensuresafeuseandthered
indicatorlightwillcomeonabovetheresetbutton.Ifyouwishto
continueyoursteamingsession:
• TurnOn/Offswitchto“Off”positionandunplugthepowercord
• RemoveandrefillwatertankbyfollowingStep1under
InstructionsforUse
• Plugthesteamercordintoa120VACelectricaloutlet.
• Pushtheresetbuttononsideofunit
• TurnOn/Offswitchto“On”position
6.WhenyouarefinishedwithyoursteamingsessionplacetheOn/Off
switchintheOffpositionandremovetheplugfromtheoutlet.
NOTE:Becautiouswhenhandlinguntilsteamerhasfullycooled.
Figure 6
Figure 7
Figure 8
Handle
Hose
Hose Connector
Steamer Nozzle
Fabric Brush
Hanger Attachment
Crease
Clamp
Pole
Clips
Pole Connector
Water Tank
On/Off Switch
Casters
Indicator Light
Reset Button
Figure 10
 previous next