Filter
Top Products
SKU 66738 For technical questions, please call 1-800-444-3353. Page 7
SPECIFICATIONS
Electrical Requirements 120 V~, 800 W
Power Cord
112" L, 3-Prong
Grounded
Temperature Range 147° - 442° F
Temperature Setting
Heat
Setting
Temperature
Range F
Time to Reach
1 147° - 190° 2 Minutes
2 230° - 298° 3 Minutes
3 311° - 379° 3.5 Minutes
4 374° - 442° 4 Minutes
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Work Piece and Work Area Set Up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the power cord along a safe 2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to al-
low free movement while working.
There must not be hazardous ob-3.
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
General Operating Instructions
Place the Iron Holder (6) on a at, 1.
level, non-ammable surface.
Wear ANSI-approved safety goggles 2.
and heavy-duty work gloves during
use. Forced-air ventilation may be
required depending on the type of
glue being heated.
Turn the Heat Control Knob (8) to the 3.
“OFF” position.
Place the Iron securely into the Iron 4.
Holder.
Turn the Heat Control Knob to the 5.
setting desired and wait until the Iron