Filter
Top Products
SKU 66738 For technical questions, please call 1-800-444-3353. Page 10
Troubleshooting
Problem Possible Causes Likely Solutions
Tool will not heat
No power at outlet.1.
Cord not connected.2.
Heat Control Knob in OFF 3.
position.
Check power at outlet.1.
Check that cord is plugged in.2.
Turn Heat Control Knob to a heat setting 3.
position.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
PARTS LIST
Part Description
1 Handle Set w(8) Screws
2
Cord Set (Relief Spring, Wire Connection
Clip, two Screws
3
Thermostat w/ Extension Post for Control
Knob
4 Top Sole Plate w/ve Screws
5 Bottom Sole Plate, Aluminum, Flat
6 Iron Holder
7 Internal Wire Set (2 pieces)
8 Heat Control Knob
9 Heat Shield w/2 Screws and (1) Washer
10
Gasket (Top of heat shield for Handle
Mount)
11
Gasket (Between Heat Shield for top of
Sole Plate)
12 Heating Element