Filter
Top Products
Figure 3
Figure 2
Figure 1
Install the water inlet hose
Connect the Water Inlet Hoses
1. Insert a new flat washer into each end of the inlet hoses. Firmly seat the washers
in the coupling. ( As figure 1)
2. ttach the water inlet hoses to the hot water faucet and the cold water
faucet. Using pliers, tighten the coupling . ( As figure 2)
NOTE: Do not overtighten. Damage to the valves can result.
Respectively a
5. Check for leaks
(1). Swing the water inlet hose gently to confirm if it's suitable.
(2). Turn on the water faucets and check for leaks. A small amount of water might
enter the washers. You will drain this later.
3. Run water through both faucets and inlet hoses, into a bucket or laundry tub, to get
rid of particles in the water lines that might clog the inlet valves screens.
4. Attach the hose connected with hot water faucet to the HOT water inlet valve(sign
with "H') . Attach the hose connected with cold water faucet to the COLD water
valve(sign with "C"). ( As figure 3)
NOTE: Do not overtighten. Damage to the valves can result.