Filter
Top Products
English
3. Install the drain hose to the side of the washer using drain hose clamp. The drain
hose must be placed into a drainpipe or sink at least 1
1
/2 inches in diameter.
Use the gooseneck to hold hose in place. To avoid possible water back up, the
drain hose must reach height of at least 31
1
/2 inches minimum and 40 inches
maximum.
Note: “Y Adaptor” shown in above figure is only for illustration. It is not provided
in the box as an accessory. If you need to utilize this type of hookup, you can
purchase a “Y Adaptor” from your nearest hardware store.
4. Plug in the Washer to a regular 115 Volt / 60 Hz, 15 Amps outlet.
Note: Inspect carefully for any leaks around and back of the machine. If there is a
leak then double check to see if any connections are loose. You may need to
tighten loose connections.
CAUTION: If after completing these steps, you are unsure that unit is properly
installed, contact a qualified installer. To ensure that your Washer is
properly installed it is recommended that it be installed by a certified
installer.
Water Supply Hose
Drain Hose
Goose Neck
Water Inlet
Hose Bend
SINK
“Y” Adapter
25
XQB60-91BF MANUAL 10/22/01 11:42 AM Page 26