Filter
Top Products
English
The machine beeps and display shows error codes:
E0 – This code is displayed when the washer door is not shut properly during the
delay start mode.
Close the washer door properly to continue.
E1 – This code is displayed when the draining is too slow.
The hose could be blocked, cut or not properly set.
Adjust the hose properly in order to drain. Replace the new hose if it is cut.
E2 – This code is displayed when the washer stops running during the
Wash ---> Spin ---> Rinse mode.
The washer door is not closed properly.
Close the top washer door properly to continue.
E3 – This code is displayed when the washer does not spin.
This is due to the washer not leveled properly or the tub is overloaded.
Adjust the leveling legs to balance the washer. Take out some clothes and
rearrange clothes inside the tub.
E4 – This code is displayed when incoming water flow is very slow.
This is due to not having the faucet open properly.
Open the water faucet properly to increase the incoming water flow.
E5 – This code is displayed when incoming hot water temperature exceeded over
140 Degree F/60 Degree C.
You must regulate incoming hot water temperature as shown above. You must
let the hot water cool down. Once the hot water has cooled down, you must
press “Start/Pause” button to resume the cycle.
Problems with water:
• Not enough water coming out: Water faucet may need to be turned on fully.
Water hoses may be tangled up or wrinkled up. Straighten up hoses. Check water
level selection, it may need to be readjusted.
• Water leaks: This is due to not properly installing drain hose or fill hoses. Your
home drain may be clogged or having constant water pressure. You may need to
tighten hoses, check the plumbing or call a plumber.
• Water will not drain: This is due to not installing your drain hose properly. You
may need to connect the drain hose properly. Check the position of the drain
hose.
• There may be some water flowing out of the drain hose in the first use of the
machine. This is due to the remaining water left in the tub at the factory to inspect
and test the performance of the unit to assure the best quality.
20
XQB60-91BF MANUAL 10/22/01 11:42 AM Page 21