Filter
Top Products
7
5. Heavy Clothes (Bed Sheet, Towel etc.) : 5 min.
Fig. 1 Fig. 2
Place the SPINNER CAP in the tub as shown in the figure 2.
the balance of the tub. (figure 1)
Remove the power plug from main power supply.
Tilt spinner tub with slight pressure.
Pick up the laundry.
Final step
Empty the spin tub, then turn the drain selector knob to ‘WASH’ to discharge the
washing water and turn the knob to ‘Heavy or Normal’ when water is completely drain out.
Then remove power plug from main power supply.
How to Spin
8
Pull out the lint filter from the lock, use fingers
to press and pull out at the part of the lint
filter’s side
Note : It is recommended to clean the lint filter regularly.
Care and Maintenance
IF ANY ABNORMALITY IS FOUND, CHECK THE FOLLOWING BEFORE CALLING FOR SERVICE CENTER
improperly, please contact the nearest SERVICE CENTER. (Phone nos. mentioned on last page)
Trouble Shooting
Spinner cap
Cleaning the Wash Tub
1. After washing is complete, fill fresh water above the level of pulsator without
adding clothes.
2. Run the machine for 1~2 minutes turn the knob to “DRAIN” position when pulsator
is still rotating.
3. When water is completely drained out, turn the knob to “Heavy or Normal” position.
4. Finally turn off the machine.
1. Cotton clothes : 5 min.