Filter
Top Products
5
1) Install the Washing machine in a well-ventilated, safe place.
Machine should be put on flat ground and where can you
connect the power supply. It is recommended to place the
washing machine on a leveled floor and avoid a place where
the washing machine can be exposed to direct sunlight.
2) Insert the power plug firmly into the main power supply.
3) Water supply in the inlet hose can be adjusted to Wash Tub
or Spin Tub.
4) The feeding water indicator -
When the water spills out of the hole above the label, it
means too much water has been supplied. Adjust the water
tap.
5) Pull out the drain hose from the washing machine. When using
the machine for the first time, you may find water
remaining in the drain hose. It was used for the factory
performance test. It does not imply any malfunction.
6
RINSING :
1. Fill the water up to desired level depending on cloth load.
2. Set WASH TIMER to 5 ~ 10 min. position to RINSE.
3. When you finish rinsing, drain off the water from the tub by turning the knob to “DRAIN” position.
Transfer clothes to Spin Tub for Spinning.
1. The machine should be put on Flat Ground.
2. Ensure Three Core Power Plug seat must have Ground Connection.
3. Lay down the Drain Hose.
4. Connect the water Inlet Hose to Water Tap.
5. Remove objects like coins, pins etc., from clothes before washing. They may damage your clothes
and clog the drain system.
6. According to the weight of cloth, adjust the level of water.
7. Switch ON power.
1. Set the wash selector knob to "Heavy or Normal".
2. Fill the tub with water according to the weight of cloth (Refer table 1 and 2).
3. Put the clothes in the tub. Do not put an excessive amount of laundry, in the tub. (Refer table 1 and 2).
4. Put recommendable quantity of detergent as mentioned in Table 1.
5. Set Wash Time upto 15min, depending on your cloth load & type (Refer Table 2)
6. When washing is completed, drain off the washing water by adjusting the knob to "DRAIN" position
7. After the washing water is discharged, turn the knob switch to "HEAVY / NORMAL" position.
8. Fill the water up to the desired level for rinsing.
How to Install
How to Wash
Preparation for Washing
With spin shower, the remaining detergent in the clothes will be removed and you can save on additional
rinsing time and water. (However, if water from the tap contains rust and / or dirt, do not perform spin shower.)
Direct water to spin tub by fixing inlet hose to spin water inlet.
Spin Shower Rinsing
3. Turn OFF the tap and then spin for about 1 ~ 5 minutes.
Note : Actual quantities of load may vary depending on the material size of laundry items.
Note : If movement of cloth is too slow, remove some of the cloth until a steady movement is observed.
3.0 Kg
3.0~4.5 Kg 4.5~6.2 Kg 6.2 Kg or ABOVE
LOW
Medium High Over Flow
45 gm
55 gm 65 gm 70 gmAmount of Detergent
30 gm
35 gm 40 gm 45 gmAmount of concentrate Detergent
25 ml
30 ml 35 ml 40 mlAmount of Softener
Table 1: Detergent Guide
Less than 3.0 kg
5.0 kg and above
NORMAL
NORMAL
NORMAL
HEAVY HEAVY
HEAVY
HEAVY
HEAVY
NORMAL
Wash 0-15 minutes
10-15 minutes
10-15 minutes
Table 2: Laundry Guide
WASH LOAD
Water Level
3.0 ~ 4.0 kg
4.0 ~ 5.0 kg
HEAVY
HEAVY
HEAVY