Filter
Top Products
Washing sequence
7
Spin timer
Wash timer
(To set to below 2 minutes,
first set to 6 minutes then
turn it back. This can increase
the service life of the timer.)
(to set to below 1 minute,
first set to 2 minutes then
turn it back. This can increase
the service life of the timer.)
Water inlet
Wash selector
(Delicate, normal,
Drain)
SPIN TIMER
WASH TIMER
WASH SELECTOR
OFF
Ç¿Ï´
±ê×¼
ÅÅË®
DRAIN
DELICATE
NORMAL
OFF
Figure 4
WASH TIMER
Wash
1.Water-filling selector
Set the water inlet selector to the "WASH" side.
(Figure 1)
Figure 2
SPIN
WASH
Figure 3
WASH SELECTOR
Figure 5
WASH SELECTOR
Ç¿Ï´
±ê×¼
ÅÅË®
DRAIN
DELICATE
NORMAL
OFF
Ç¿Ï´
±ê×¼
ÅÅË®
DRAIN
DELICATE
NORMAL
Energy test program 18 min Normal Warm Wash (35'C), 9 min Rinse, 5 min spin (1/2 load).
Add the clothes load. Fill the wash tub to the maximum water level. Water at 35'C.
While it is filling (half) add the detergent/PBIS mixed with 1 litre of Min.35'C water.
Wash on "normal" for 3 minutes. Then fill the wash tub again to the maximum water level. Water at 35'C.
Wash on "normal" for 15 minutes. Drain for 5 minutes. Divide load into two halves.
Spin each half load for 5 minutes. Place the clothes in the wash tub and then fill with cold
(20'C) water to the maximum level.
Wash/rinse for 9 minutes. Drain for 5 minutes.
Divide load into two halves. Spin each half load for 5 minutes. Program end.
Detergent : drum type .
For best results , we recommend mixing detergent with warm water ,and using max anti-foam .
2.Fill with water to the set level and add the
dissolved washing powder. (Figure 2)
3.Place the clothes into the water.
4.Select the wash mode, either "delicate"
or "normal". (Figure 3)
5.Select the washing time
Select the washing time according to the load
size and how dirty the clothes are. (Figure 4)
Note: For a full load on the normal cycle first
wash for 3 minutes, the clothes will absorb
the water. At the end of 3 minutes add extra
water up to the maximum water level mark.
Then wash for a further 15 minutes using
the wash timer.
6.After washing, set the "WASH
SELECTOR" at "DRAIN". (Figure 5).