Haier WD-9999-14 Washer User Manual


 
Before calling for service, determine the symptoms and follow the suggested
solutions:
Washer does not operate:
• Check if the unit is plugged in. The plug may have come loose.
• Check if the electrical wall receptacle is of proper voltage.
Check if the circuit breaker needs to be reset or if the fuse needs to be
replaced.
Check if the washer is overloaded. Reload and redistribute the clothing to
rebalance the machine.
Check if the door is open. You may have to close the door properly.
Check if the program selections are set properly. You may have to adjust the
settings.
Check the Power “ON/OFF” button to see if it is in the OFF position. You may
need to press the button to set it in the ON position.
Check if the “Start/Pause” button is on “Pause” mode. Press this button to start
the wash process.
The wash process is paused. This is normal. The clothing sensor is checking to
verify that there are clothes inside the washtub. Water will be added
approximately 48 seconds later.
The pulsator pauses during incoming water flow in the wash and rinse cycle.
This is normal. This prevents splashing during water inlet.
The washer may need to be reloaded and the clothes may need to be
rebalanced.
English English
troubleshooting guide
23