Filter
Top Products
Loading the Washer
• Load each item loosely.
• Separate the white from the colored clothing. Separate heavy fabrics from light
fabrics.
• Carefully check all pockets and cuffs for foreign items. They can easily slide
into the tub and cause damage to the tub and/or make disturbing noises during
cycles.
• Always balance the laundry load evenly within the washer tub, so there is no
single heavy areas and all the laundry is evenly distributed.
Lint Filter and Water Filter
• The Lint filter is located inside the washer drum. A small nylon bag collects lint
and residue from clothes during the wash cycle.
NEVER wash your clothes without the filter in its compartment
inside the tub.
• You must clean the filter after every load for the best results. Push down the tab
in the filter to remove. Clean and slide the filter back in place.
• There is also a filter in the water inlet valve. This prevents foreign particles in
the water from entering the washer. Clean this at least once a month.
Steps for the Wash Process
1. The lint filter must be cleaned and in place before you start washing
2. Turn the power ON by pressing the “ON” button.
3. Press “Cycle Select” to select the wash program.
4. Select the water level.
5. Add the detergent.
6. Add the wash load.
7. Press the Start / Pause button.
8. After the washing machine starts, you may change the Cylcle or program by
turning OFF the machine and then restarting to make the new selection.
If the washer is turned ON without any water in the tub, it will start to
spin after a few minutes. The pulsator will not rotate unless the water is
filled to a selected level.
Note: Do not use the “HEAVY Wash” program for woolen clothing.
English English
16
Note:
Note:
Note: