Filter
Top Products
Install the bottom plate
4
Please install and adjust the machine according to the requirement of
the manual. It is very important to your
operating the machine.
safety and the correct
Installation and adjustment
The largest allowable slope of the base of the machine is 2 .
Slanting or rough ground will result in unstable running or stoppage of the
machine. Please adjust it by the following method:
Confirm it is level
Adjust the adjustable leg:
2
Adjust the position
1 .To twist the adjustable leg, please first
lift up the side of the leg slightly, loosen
the adjustable nut, and twist the leg.
2 . After adjustment, fasten the nut.
After opening the package, please take out the lint
filter from the document bag, install it to the inner
tub. See the figure opposite.
Install the lint filter
Inner tub
Lint filter
Back
Front
Soft object
Screw
Bottom plate
Fasten
Loosen
High
Low
adjustable nut
Adjustable
feet
The purpose of the bottom plate is to block noise
and give a quiet performance from the washing
machine during operation.
Steps:
1. Lay the washer on its back.
2. Place the plate on to the bottom of the machine.
3.Use a screwdriver to tighten the screws securing
the panel to bottom of the washer.
4.Once all screws are tight and the panel is secure return
the washer to its standing position.
Please ensure the lint filter is installed correctly and in
good condition to ensure the water outlet is not blocked
or the flow altered. If the lint filter is lost please contact
the local after -sales service department.